ok - I am lame - I have looked in the book and searched on here - but I dont see how to "copy" the keyframes I have created in this slideshow.
I have about 750 images in a slideshow I am creating.........the advice on here was to break this up into a bunch of little slideshows then combine them all together when I am done - GOOD advice.
BUT
I have 55 images in a small slideshow - and I have created 12 different keyframe paths for the images to flow on.........
some are closeups that pan back
others go from left to right fast..........others are slow
some go from extreme close up to half way pullback and then stop for 2 seconds...........
anyway -
I wanna use these same 12 paths in OTHER slideshows I am creating
How to do this?
bring in the other 55 slides and apply the attributes to THOSE slides and then erase the ones that were just up there that I stole the keyframes from?
that is about the only way to do it - but I thought there may be a way to save these for a future segment that I dont wanna pull this slideshow from...........